Mode Door Actuator: Removal
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, and 2002 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Open hood and disconnect the negative battery cable remote terminal from the remote battery post. Remove the left and right underpanel ducts.
- Remove the floor console. Remove the center floor heat adaptor duct.
- Remove the rear seat heat forward adaptor duct. Loosen the center support bracket and pry rearward to gain access to the actuator.
- Remove the actuator retaining screws. Then pull the actuator straight down. Upon removal, note the shaft position of the actuator, because the shaft on this motor is keyed. When installing a NEW actuator, its shaft must be positioned in the same location. See Figure . Remove the electrical connection on the actuator.