Blower Motor: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, and 2002 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower motor in the HVAC housing and tighten the mounting screws. Install the blower motor housing cover.
- Position the blower motor wiring grommet in the blower motor housing cover. Connect the blower motor harness connector to the blower motor resistor block/power module.
- Install the lower right under panel duct. Connect the negative battery cable remote terminal to the remote battery post.