Blend Door Actuator: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, and 2002 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wire harness connector to the blend door actuator. Install the blend door actuator on the HVAC housing, making sure its keyed shaft is positioned properly.
- Install the 3 fastener screws and tighten. Install the left and right underpanel silencer/ducts. Connect the negative battery cable remote terminal to the remote battery post.