LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Disc Brakes) >> Removal & Installation >> Parking Brake Shoes >> Installation

Parking Brake Shoes: Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install front brake shoe hold-down clip.
  2. Install rear brake shoe and the upper brake shoe-to-shoe return spring.
  3. Pull rear brake shoe over anchor block until properly located on adapter.
  4. Install the lower shoe-to-shoe return spring.
  5. Install brake shoe adjuster assembly with star-wheel rearward.
  6. Install rear brake shoe hold-down clip.
  7. Adjust brake shoes to a diameter of 6.73" (171 mm).
  8. Install rear hub and bearing assembly on spindle.
  9. Install hub and bearing assembly washer and retaining nut. See TORQUE SPECIFICATIONS  .
  10. Install the wave washer, retaining nut and cotter pin.
  11. Install hub and bearing assembly dust cap.
  12. Install rear brake rotor. See ROTOR  .
  13. Install rear disc caliper on the adapter. See CALIPER  .
  14. Install wheel and tire assembly. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals