LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Disc Brakes) >> Removal & Installation >> Parking Brake Cables >> Installation (Intermediate Cable)

Installation (Intermediate Cable)

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate parking brake cable.
    2. NOTE: When guiding the cable towards the front of rear crossmember from the left side, make sure the cable is routed between the rear suspension crossmember and the frame rail crossing below the rear parking brake cable. It should also be routed below the brake lines at this point.
  2. Install the intermediate cable to the tensioner bracket by snapping it into place.
  3. Reinstall retainer clip on top of left side of crossmember, around intermediate cable and into place.
  4. Connect the intermediate cable to the right rear cable.
  5. Install the intermediate cable through the hole in the body torque box. See Figure . Install the bolt attaching the intermediate cable retainer to the body torque box.
  6. Connect the intermediate cable to the front cable connector.
  7. Adjust parking brakes. See PARKING BRAKE CABLE  under ADJUSTMENTS.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals