Master Cylinder: Removal
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect brake fluid level switch wire connector on the side of the master cylinder reservoir.
- Disconnect primary and secondary brake lines from master cylinder housing. Install plugs at brake tube outlets.
- Remove the 2 nuts attaching the master cylinder to the power brake booster. See Fig 1 .
- Slide master cylinder straight out from the booster.