LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Disc Brakes) >> Removal & Installation >> Brake Pedal >> Installation

Brake Pedal: Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the pedal has a properly installed bushing on each side of the pedal. See Figure .
  2. Lubricate the brake pedal pivot shaft and brake pedal bushings using Mopar(R) Lubriplate or an equivalent.
  3. Install the brake pedal in the pedal bracket. See Figure . Align the hole in brake pedal with the pivot shaft holes in the pedal bracket.
  4. Install the brake pedal shaft. See Figure .
  5. Install the nut on the end of the brake pedal pivot shaft. See TORQUE SPECIFICATIONS  .
  6. Install the power brake booster input rod on the brake pedal pin.
    7. CAUTION: When installing the retaining clip on the brake pedal pin, a NEW retaining clip must be used to ensure the retention of the power brake booster.
  7. Install a NEW retaining clip on the brake pedal pin
  8. Install brake lamp switch. See BRAKE LAMP SWITCH  .
  9. Connect the remote battery ground cable to the ground stud on the right front strut tower.
  10. Check the operation of the brakes and brake lamp switch.
scientia non olet · About LEMON Manuals