Brake Fluid Reservoir: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Install NEW housing-to-reservoir grommets in master cylinder housing. See Figure .
- Lubricate brake fluid reservoir-to-grommet mounting area with clean brake fluid. Place reservoir in position over grommets. Seat reservoir into sealing grommets using a rocking motion while pushing down on reservoir.
- Make sure bottom of reservoir touches the top of both sealing grommets.
- Install the 2 brake fluid reservoir-to-master cylinder retaining pins. See Figure .
- Bleed master cylinder. See MASTER CYLINDER under BLEEDING BRAKE SYSTEM.
- Install the master cylinder on vehicle. See MASTER CYLINDER .