Monitored & Set Conditions
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
Circuit is monitored in 2 tests. Test #1: Vehicle speed must be greater than 20 MPH to enable. TEST #2: Speed must be zero MPH and brake switch indicate on. DTC will set in Test #1 if vehicle speed goes to zero MPH without brake input. Condition must be repeated 15 times to set fault. DTC will set in Test #2 if vehicle speed goes above 20 MPH for more than 6.0 seconds without a change in brake state. Condition must be repeated 15 times to set fault.