LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Automatic Transmission Diagnosis) >> Performance Tests >> Hydraulic Pressure Tests >> Overdrive Clutch Pressure Test

Overdrive Clutch Pressure Test

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pressure tap plug and install pressure gauge in overdrive clutch pressure tap. See Figure.
  2. Place gearshift lever in "OD" position. Allowing front wheels to rotate, accelerate until vehicle speed indicates 20 MPH.
  3. Overdrive clutch pressure should be 74-95 psi (5.2-6.7 kg/cm2 ). Place gearshift lever in "3" position and increase vehicle speed to 30 MPH. Transaxle should be in second gear.
  4. Overdrive clutch pressure should now be less than 5 psi (.35 kg/cm2 ). This pressure test checks overdrive clutch hydraulic circuit and shift schedule. Remove pressure gauge. Install and tighten pressure tap plug to 53 INCH lbs. (6.0 N.m).
scientia non olet · About LEMON Manuals