LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Automatic Transmission Diagnosis) >> Performance Tests >> Hydraulic Pressure Tests >> Low-Reverse Clutch Pressure Test

Low-Reverse Clutch Pressure Test

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pressure tap plug and install pressure gauge in low-reverse clutch pressure tap. See Fig 1.
  2. Start engine and place gearshift lever in "L" position. Allowing front wheels to rotate, accelerate until vehicle speed indicates 20 MPH.
  3. Low-reverse clutch pressure should be 115-145 psi (8.0-10.1 kg/cm2 ). This pressure test checks oil pump output, pressure regulation and low-reverse clutch hydraulic circuit and shift schedule. Remove pressure gauge. Install and tighten pressure tap plug to 53 INCH lbs. (6.0 N.m).
Fig 1: Identifying Pressure Tap Locations
G94E36644Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals