LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Power Door Lock System & Trunk Release System) >> Removal & Installation >> Door Trim Panel >> Installation (Rear)

Installation (Rear)

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place trim panel in position on door.
  2. Connect the courtesy lamp.
  3. Connect the wiring harness clips to the trim panel.
  4. Connect the power window switch wire harness connector.
  5. Connect the rear door speaker wire connect.
  6. Connect the remote handle linkage.
  7. Hook the trim panel over the sheet metal flange.
  8. Insert the forward 4-way alignment guide into position. Insert the rearward 2-way alignment guide into position.
  9. Engage the 3 retaining clips to attach door trim panel to door sheet metal inner panel, up to 3 ratchet clicks.
  10. Install 3 screws to the bottom of the door. See TORQUE SPECIFICATIONS  .
  11. Install screw in the remote bezel and close the trim plug.
  12. Install screw in pull cup, and close the trim plug.
scientia non olet · About LEMON Manuals