LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Power Door Lock System & Trunk Release System) >> Removal & Installation >> Door Trim Panel >> Installation (Front)

Installation (Front)

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place door trim panel in position.
  2. Install wire harness clips into door trim panel.
  3. Connect the courtesy lamp, if equipped.
  4. Connect the radio speaker wire connector.
  5. Connect the power window switch wire connector.
  6. Connect the power door lock switch wire connector.
  7. Connect the power mirror switch wire connector.
  8. Connect the linkage to the handle assembly.
  9. Hook door trim panel over the sheet metal flange.
  10. Insert the forward 4-way alignment guide into position. Insert the rearward 2-way alignment guide into position.
  11. Engage rear retaining clips to attach door trim panel to inner sheet metal panel, up to 3 ratchet clicks.
  12. Install 3 screws in the speaker area.
  13. Install 2 screws in the instrument panel interface area.
  14. Install screw in the remote bezel, and close trim plug.
  15. Install screw in pull cup, and close trim plug.
  16. Install 3 screws to the bottom of the door. See TORQUE SPECIFICATIONS  .
  17. Place speaker grille in position on trim panel.
scientia non olet · About LEMON Manuals