LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Air Bag Restraint Systems) >> Removal & Installation >> Occupant Restraint Controller (Orc) >> Removal (5-Passenger Model)

Removal (5-Passenger Model)

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove shifter knob fastener, and remove shifter knob. Remove 2 retaining screws securing shifter bezel. Disconnect power outlet electrical connector and remove bezel. Remove left instrument panel end cap covering fuse block. Remove 2 steering column cover retaining screws and cover. Open glove box. Pull down on glove box door until glove box drops and retaining screws in upper and lower left corner of glove box bin are visible.
  3. Pull off right side console panel. Remove 2 retaining screws and left side console panel. Slide Red connector position assurance tab out on ORC electrical connector. Press down on locking latch and disconnect ORC 23-pin connector. Remove 2 lower retaining screws on driver-side of ORC. Loosen top retaining screw on driver-side of ORC. Remove ORC (Loosen passenger-side retaining screw if ORC cannot be removed).
scientia non olet · About LEMON Manuals