Intermittent Problem Diagnosis
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Dodge Stratus, 2002 Dodge Neon, 2002 Dodge Intrepid, 2002 Chrysler Sebring, and 2002 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Intermittent fault testing requires duplicating circuit or component failure to identify the problem. These procedures may lead to PCM setting a Diagnostic Trouble Code (DTC) which may help in diagnosis.
If problem vehicle does not produce DTC, monitor voltage or resistance values using a DVOM while attempting to reproduce conditions causing intermittent fault. A status change on DVOM indicates a fault has been located.
Use a DVOM to pinpoint faults. When monitoring voltage, ensure ignition switch is in ON position or engine is running. Ensure ignition switch is in OFF position or negative battery cable is disconnected when monitoring circuit resistance. Status changes on DVOM during test procedures indicate area of fault.