Removal & Installation (2.7L)

WARNING: This page is about a different car, the 2002 Dodge Stratus and 2002 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Idle Air Control (IAC) motor is located on throttle body. See Fig 1. Disconnect negative battery cable. Disconnect IAC motor harness connector. Remove IAC motor retaining screws. Remove IAC motor.
To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .

Fig 1: Locating Crankshaft Position Sensor & Idle Air Control Motor (Sebring Convertible, Sebring Sedan & Stratus Sedan -- 2.7L)

Courtesy of DAIMLERCHRYSLER CORPORATION