Removal & Installation (2.4L)

WARNING: This page is about a different car, the 2002 Dodge Stratus and 2002 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Power steering pressure switch is not used on the 2.7L.

Power steering pressure switch is located on power steering gear assembly. See Fig 1. Disconnect negative battery cable.
Raise and support vehicle. Disconnect power steering pressure switch harness connector. Using a crowfoot and a long extension, remove power steering pressure switch.
To install, reverse removal procedure. Tighten power steering pressure switch to specification. See TORQUE SPECIFICATIONS .

Fig 1: Locating Power Steering Pressure Switch (2.4L)

Courtesy of DAIMLERCHRYSLER CORPORATION