Removal & Installation
WARNING: This page is about a different car, the 2002 Dodge Stratus and 2002 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A/C pressure sensor may also be referred to as A/C pressure transducer.
A/C pressure sensor is located on the discharge line, near the condenser. It is not necessary to discharge the refrigerant system. Disconnect A/C pressure sensor harness connector. Using a 14-mm open-end wrench, remove A/C pressure sensor. A slight release of pressure trapped in the fitting may be experienced. To install, reverse removal procedure using a NEW "O" ring. Tighten A/C pressure sensor to specification. See TORQUE SPECIFICATIONS .