Removal (3.5L)
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Knock sensor is located on cylinder block, below lower intake manifold. See Fig 1. Manufacturer states it is necessary to remove upper and lower intake manifolds. See appropriate article in ENGINES.
- Disconnect knock sensor harness connector. Remove knock sensor from cylinder block. To install, reverse removal procedure. Tighten knock sensor to specification. See TORQUE SPECIFICATIONS .CAUTION: Over or under tightening may effect knock sensor performance resulting in possible improper spark control.