LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Ignition Coil >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. All engines are equipped with a coil on plug ignition system. Each cylinder has a dedicated coil that sits atop each spark plug. Ensure area around ignition coil is clean before removing. Disconnect ignition coil harness connector. Remove ignition coil retaining bolts.
  2. On 3.5L, loosen ignition coil retaining bolts evenly. On all engines, DO NOT lose spacers located under ignition coil when removing. Remove ignition coil. To install, reverse removal procedure. Tighten ignition coil retaining bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals