LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Throttle Body >> Removal & Installation (2.7L)

Removal & Installation (2.7L)

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable at remote battery terminal on passenger's side strut tower. Disconnect air intake hose from throttle body. Hold throttle lever on throttle body in full throttle and disconnect throttle cable and speed control cable from throttle body.
  2. Remove throttle cable mounting bracket. Disconnect electrical connectors and vacuum hoses at throttle body. Remove throttle body bracket from bottom of throttle body. Remove throttle body bolts. Remove throttle body and gasket.
  3. To install, reverse removal procedure using NEW gasket. Tighten throttle body bolts to specification. See TORQUE SPECIFICATIONS . Hold throttle lever on throttle body in full throttle when installing throttle cable and speed control cable on throttle body.
scientia non olet · About LEMON Manuals