LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Pump Inlet Strainer >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fuel pump inlet strainer is mounted on fuel pump module. Remove fuel pump module. See FUEL PUMP MODULE .
  2. Spread locking tabs on bottom of fuel pump module and remove fuel pump inlet strainer from fuel pump module. See Figure. Remove "O" ring from end of fuel pump module.
  3. To install, reverse removal procedure using NEW "O" ring. Lubricate "O" ring with engine oil before installing. Install "O" ring in fuel pump inlet strainer before installing fuel pump inlet strainer on fuel pump module.
  4. Ensure "O" ring sets evenly on inside of fuel pump inlet strainer. Ensure locking tabs on fuel pump module fully engage on fuel pump inlet strainer. Reinstall fuel pump module using proper procedure. See FUEL PUMP MODULE .
scientia non olet · About LEMON Manuals