Removal & Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Drain cooling system until coolant level is below cylinder head. Disconnect Engine Coolant Temperature (ECT) sensor harness connector. ECT sensor is located near front of engine and contains a Black/Light Blue wire and Tan/Black wire in harness connector. See Fig 1 or Fig 2 .
- Remove ECT sensor. To install, reverse removal procedure. Tighten engine coolant temperature sensor to specification. See TORQUE SPECIFICATIONS . Fill and bleed cooling system. See COOLING SYSTEM BLEEDING under COOLING SYSTEM.