Brake Switch: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before installing brake switch, plunger on brake switch must be pulled outward to fully extended position to ensure proper brake switch adjustment.
- Pull plunger on brake switch outward to fully extended position. Install brake switch harness connector. Depress brake pedal as far as possible. Install brake switch in mounting bracket. Ensure alignment tab on brake switch aligns with opening on mounting bracket.
- When brake switch is fully installed in mounting bracket, rotate brake switch clockwise approximately 30 degrees. To ensure proper brake switch adjustment, gently pull brake pedal back toward brake switch as far as possible. DO NOT apply excessive pressure on brake pedal and brake switch. Check operation of brake lights.
CAUTION:
When adjusting brake switch, DO NOT pull brake pedal back toward brake switch with excessive pressure, or brake switch may be damaged.