Height-Sensing Proportioning Valve: Removal

1. Using brake pedal depressor, move brake pedal downward, and lock brake pedal to a position past the first one inch of brake pedal travel. This prevents brake fluid from draining from master cylinder when brakelines are disconnected from height-sensing proportioning valve.
2. Remove the four brakelines from the inlet and outlet ports of the proportioning valve. Remove the two bolts attaching the proportioning valve and bracket to the vehicle. See Fig 1.
3. Slide the bracket out from under rear track bar bracket. Lower the valve down enough to pull its actuator rod out of the axle bracket and remove the proportioning valve from the vehicle.

Fig 1: Removing/Installing Proportioning Valve

Courtesy of CHRYSLER CORP.