LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Voyager EC >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Disc Brake Pads >> Installation

Front Disc Brake Pads: Installation

CAUTION: Use care when installing the caliper onto the disc brake adapter to avoid damaging the boots on the caliper guide pins.
NOTE: Perform steps 1 - 5 on each side of the vehicle.
  1. Place the brake pads in the adapter anti-rattle clips.
  2. Completely retract the caliper piston back into the bore of the caliper.
  3. Install the disc brake caliper over the brake pads on the brake caliper adapter.
  4. Align the brake caliper guide pin bolt holes with the guide pins. Install the brake caliper guide pin bolts and tighten to specification. See TORQUE SPECIFICATIONS .
  5. Install the tire and wheel assembly. Tighten wheel lug nuts to specification. Lower the vehicle. Pump the brake pedal several times. This will set the pads to the brake rotors.
  6. Check and adjust the brake fluid level as necessary. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake pads.
scientia non olet · About LEMON Manuals