Calibration Test
The Cluster Calibration Table contains the proper calibration points for each gauge. See GAUGE CALIBRATION POINTS table. If the gauge pointers are not calibrated, a problem exists in the cluster. If any gauge is out of calibration, replace the cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. If gauges operate properly, go to ODOMETER SEGMENT TEST .
GAUGE CALIBRATION POINTS
| Gauge Calibration Points | Gauge Reading | |
|---|---|---|
| Speedometer | ||
| 1 | 0 MPH | |
| 2 | 20 MPH | |
| 3 | 60 MPH | |
| 4 | 100 MPH | |
| Tachometer | ||
| 1 | 0 RPM | |
| 2 | 1000 RPM | |
| 3 | 3000 RPM | |
| 4 | 6000 RPM | |
| Fuel Gauge | ||
| 1 | Empty | |
| 2 | 1/4 | |
| 3 | 1/2 | |
| 4 | Full | |
| Temperature Gauge | ||
| 1 | Cold | |
| 2 | 1/4 | |
| 3 | 3/4 | |
| 4 | Hot | |