Instrument Panel Top Cover: Installation

1. Place the top cover into place. Line up the fasteners with each slot and firmly, pushing forward, snap into place. See Fig 1.
2. Install the two top cover attaching screws. See Fig 2.
3. Place the center bezel into position, lining up the fasteners with the slots and snap into place.
4. Install the HVAC control knobs.
5. Install the one center bezel retaining screw.
6. Connect the harness connector to the front power window switch. Align the front power window switch into the instrument panel center bezel opening and snap into place.
7. Install the left and right A-pillar trim.
8. Connect the battery negative cable. Close hood. Verify vehicle and system operation.

Fig 1: Removing & Installing Instrument Panel Top Cover (1 Of 2)

Courtesy of DAIMLERCHRYSLER CORP.

Fig 2: Removing & Installing Instrument Panel Top Cover (2 Of 2)

Courtesy of DAIMLERCHRYSLER CORP.