LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Neon LX, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal >> Removal (Neon - With Manual Transaxle)

Removal (Neon - With Manual Transaxle)

  1. Remove the instrument panel. See INSTRUMENT PANEL under REMOVAL & INSTALLATION in appropriate ANALOG INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.
  2. Remove the brake lamp switch. See BRAKE LAMP SWITCH  .
  3. Disconnect the clutch cable from the clutch pedal spacer. See Fig 1 .
  4. Disconnect the wiring harness connector going to the clutch pedal switches. See Fig 2 .
  5. Remove the clip securing the power brake booster input rod to the brake pedal. Remove the input rod from the brake pedal. See Figure .
  6. Remove the nuts fastening the brake pedal bracket to the power brake booster. See Figure .
  7. Remove the 2 nuts fastening the brake pedal brake to the instrument panel support. See Figure .
  8. Remove the brake pedal assembly.
  9. The pedal can be removed from it's bracket by grinding off the peened end of the shaft, removing the shaft, pedal and bushings. A service parts package is available to replace these items.
Fig 1: Disconnecting Clutch Cable (Neon - With Manual Transaxle)
G00309413Courtesy of CHRYSLER CORP.
Fig 2: Disconnecting Clutch Pedal Waring Harness Connectors (Neon - With Manual Transaxle)
G00309414Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals