LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect brake fluid level switch wire connector on the side of the master cylinder reservoir.
  2. Disconnect primary and secondary brake lines from master cylinder housing. Install plugs at brake tube outlets.
  3. Remove the 2 nuts attaching the master cylinder to the power brake booster. See Fig 1 .
  4. Slide master cylinder straight out from the booster.
Fig 1: Removing & Installing Master Cylinder Mounting Nuts
G00293133Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals