LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Caliper >> Removal (Rear)

Removal (Rear)

  1. Raise and support vehicle.
  2. Remove rear wheel and tire assemblies.
  3. Remove the 2 caliper assembly-to-adapter guide pin bolts. See Fig 1 .
  4. Remove caliper from adapter. First rotate top of caliper away from adapter. Then lift the caliper off the bottom abutment on the adapter. See Fig 2 .
  5. Support caliper assembly firmly from rear strut to prevent weight of caliper from damaging the flex brake hose. See Fig 3 .
  6. Remove rear rotor. See ROTOR  .
Fig 1: Removing & Installing Rear Caliper (1 Of 2)
G00293125Courtesy of CHRYSLER CORP.
Fig 2: Removing & Installing Rear Caliper (2 Of 2)
G00293149Courtesy of CHRYSLER CORP.
Fig 3: Storing Caliper
G00293150Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals