LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Brake Pedal >> Removal

Brake Pedal: Removal

  1. Disconnect and isolate the remote battery ground cable from the ground stud on the right strut tower.
  2. Remove the brake lamp switch. See BRAKE LAMP SWITCH  .
  3. Remove the retaining clip from the brake pedal pin securing the power brake booster to the pedal. See Fig 1 . Position a small screwdriver between the center tang on the retaining clip and the brake pedal pin. Rotate blade of screwdriver between the center tang on the retaining clip and the brake pedal pin.
  4. Remove the booster input rod from the brake pedal pin.
  5. Remove the nut from the brake pedal pivot shaft. See Figure . The pivot shaft has a flat on i to hold while the nut is removed.
  6. Remove the brake pedal pivot shaft from the brake pedal and pedal mounting bracket.
    7. NOTE: The bushings can be easily removed from the pedal by pulling them straight out each side.
  7. Remove the brake pedal with bushings from mounting bracket. See Figure .
Fig 1: Removing & Installing Retaining Clip
G00309458Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals