Brake Fluid Reservoir: Removal
- Remove master cylinder from the power brake booster. See MASTER CYLINDER
.
- Using an appropriate cleaner such as Mopar(R) Brake Parts Cleaner, clean the master cylinder housing and brake fluid reservoir.
- Remove the filler cap and empty all brake fluid from reservoir.
- Clamp the master cylinder in vise.
- Remove the 2 fluid reservoir to master cylinder retaining pins. See Fig 1
.
- Remove reservoir from master cylinder by pulling upward on the reservoir while rocking it from side-to-side. See Fig 2
.
- Remove the master cylinder housing-to-reservoir grommets. See Fig 3
.
Courtesy of CHRYSLER CORP.
Courtesy of CHRYSLER CORP.
Courtesy of CHRYSLER CORP.