LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Analog Instrument Panels >> Removal & Installation >> Instrument Panel Center Bezel >> Removal/Installation

Instrument Panel Center Bezel: Removal/Installation

  1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post. See Figure.
  2. Remove ash receiver (if applicable).
  3. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on center trim bezel. Disconnect wiring connectors to HVAC controls, cigar lighter/auxiliary power outlet and traction control switch (if equipped).
  4. Remove instrument panel center trim bezel.
    NOTE: The traction control switch, HVAC control head and cigar lighter/auxiliary power outlet must be transferred to new bezel if being replaced
  5. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals