LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting Systems - Exterior >> Rear Fog Lamp - Export >> Diagnosis And Testing - Rear Fog Lamp Export

Diagnosis And Testing - Rear Fog Lamp Export

NOTE: Battery must be completely charged (12v) prior to testing. It may also be necessary to install battery charger on the vehicles electrical system when performing this test. Refer to the Battery section of the service information for detailed information.
  1. Remove the rear fog lamp bulb and check for burned out condition, replace bulb if necessary.
  2. If bulb appears OK, reinstall the bulb in its socket and turn fog lamps ON and check for proper operation. If lamp is still inoperative proceed to Step 3.
  3. Remove lamp bulb and check for proper power (12v) and ground connections in lamp socket. If power and/or ground connections are not present, trace wire until open or short is found.
scientia non olet · About LEMON Manuals