Description - Police

There are three pair of twisted 18-gauge wires from the interior-to-front bumper beam area to be used for the auxiliary flashers, siren, speaker, or control circuit usage. The twisted pairs are taped back to the wire harness right by the wire feed to the ambient temperature sensor behind the front fascia, in front of the condenser, just to the passenger side of the vehicle centerline. All police vehicle wiring (additional circuits added) is taped back to the wire harness with green tape for identification. Refer to SYSTEM WIRING DIAGRAMS for location and circuit description. The police package includes a Wig Wag (alternating flashing of the vehicle high beam headlamps) connector underneath the instrument panel. This connector is hard wired to the front high beam headlamps and is intended for use with an aftermarket lighting control module. Refer to SYSTEM WIRING DIAGRAMS for location and circuit description.