LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Activating System (Saturn, S Series)

Activating System (Saturn, S Series)

  1. Ensure wheels are in straight ahead position. Remove key from ignition switch. Ensure AIR BAG fuse is still removed from fuse block. Connect left and right side curtain air bag Yellow 2-pin air bag connectors. Ensure instrument panel upper trim panel seal is correctly seated on forward edge, and install trim panel.
  2. Connect passenger air bag Yellow 2-pin connector. Install CPA clip. Attach connector clip to metal brace. Connect driver air bag Yellow 2-pin connector. Install CPA clip.

Install AIR BAG fuse in fuse block. Staying well away from both front air bag inflator modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.

Fig 1: Locating Driver Air Bag Yellow 2-Pin Connector (Saturn, S Series)
G00018847Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating Passenger Air Bag Yellow 2-Pin Connector (Saturn, S Series)
G00018850Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Instrument Panel Upper Trim Panel (Saturn, S Series)
G00018848Courtesy of GENERAL MOTORS CORP.
Fig 4: Locating Curtain Air Bag Yellow 2-Pin Connector (Saturn, S Series)
G00018849Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals