LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Activating System (Catera)

Activating System (Catera)

  1. Ensure ignition switch is in LOCK position with key removed. Connect right-hand (passenger) side air bag 2-pin Yellow SIR connector (if equipped). Install CPA clip. Connect passenger seat belt pretensioner 2-pin connector. Repeat procedure for driver seat belt pretensioner 2-pin connector and side air bag 2-pin Yellow SIR connector (if equipped). Install seat track covers.
  2. Connect passenger air bag 2-pin Yellow SIR connector. Install CPA clip. Install air deflector and air bag trim cover. Connect driver air bag module wiring harness connector to steering wheel SIR coil connector. Install CPA clip. Install air bag module to steering wheel. Tighten Torx screws to 72 INCH lbs. (8 N.m).
  3. Staying well away from inflator modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.
scientia non olet · About LEMON Manuals