LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Manual HVAC Systems - Except Coupe >> Diagnostic Tests >> Test O: Mode Door Feedback Failure >> Monitor & Set Conditions

Monitor & Set Conditions

Monitored with ignition switch in ON position. DTC/fault message will set when BCM detects voltage less than 0.06 voltor greater than 4.8 volts in evaporator temperature sensor signal input at BCM C2 connector terminal No. 9 (Light Green/Black wire).

scientia non olet · About LEMON Manuals