LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> SANDEN TRS-90 Scroll >> Clutch Assembly >> Removal

Clutch Assembly: Removal

  1. Disconnect and isolate negative battery cable. Remove serpentine drive belt. Without discharging A/C system or disconnecting refrigerant lines, remove compressor from mount. Position and support compressor for access. Using Spanner Wrench (C-4489), hold clutch plate and remove compressor shaft center nut.
  2. Using Puller (C-6461), remove clutch plate. Remove compressor shaft key and clutch shims. Remove external front housing snap ring. Install lip of Rotor Puller (C-6141-1) into external snap ring groove. Install Shaft Protector (C-6141-2).
  3. Install Puller Bolts (C-6461) through puller flange an into rotor puller jaws. Tighten puller center bolt clockwise until rotor pulley is free. Disconnect clutch coil lead. Scribe match marks on clutch coil and compressor for installation reference. Remove snap ring and clutch coil.
scientia non olet · About LEMON Manuals