LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> SANDEN MSC90-C Scroll >> Clutch Assembly >> Removal

Clutch Assembly: Removal

  1. Disconnect and isolate negative battery cable. Remove drive belt. Disconnect clutch coil harness connector. Without disconnecting refrigerant lines, remove A/C compressor from mounting bracket. Support compressor in engine compartment.
  2. On 2001 model year 2.4L engines, remove pulley assembly. Using Spanner (MB991367) and Pins (MB991386), remove shaft nut. Remove clutch plate, snap ring and rotor/pulley assembly. Remove snap ring and clutch coil. See Figure.
scientia non olet · About LEMON Manuals