LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> Ford SC90V Scroll >> Clutch Assembly >> Removal

Clutch Assembly: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain and measure oil from compressor. Install plugs into compressor and refrigerant lines to prevent moisture and debris contamination.
  2. Using a spanner wrench to hold clutch plate, remove shaft nut. Remove clutch plate and shim. Remove snap ring and pulley assembly. If necessary, use a 3-jaw puller to remove pulley assembly.
  3. Remove compressor thermal cut-out switch bracket. Using a twisting motion, pull up and remove thermal cut-out switch. Remove clutch coil snap ring and clutch coil. See Figure.
scientia non olet · About LEMON Manuals