LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> Ford FS-10 10-Cylinder >> Compressor Clutch Shaft Seal >> Removal

Compressor Clutch Shaft Seal: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove compressor. Remove compressor clutch assembly. See CLUTCH ASSEMBLY .
  2. Remove compressor shaft felt seal. Using low pressure compressed air and a lint-free cloth, thoroughly clean seal inside and outside of compressor nose area. Using Snap Ring Remover (T89P-19623-DH), rotate eye of snap ring toward compressor shaft. Quickly pull up snap ring while holding snap ring at an angle.
  3. Position Shaft Seal Remover (T89P-19623-BH) over compressor shaft. Push shaft seal remover downward against seal. Ensure end of shaft seal remover engages inside diameter of seal.
  4. Rotate shaft seal remover handle clockwise to expand remover tip inside seal. Pull shaft seal from compressor. Ensure dirt or other debris does not enter compressor.
scientia non olet · About LEMON Manuals