LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> Ford FS-10 10-Cylinder >> Clutch Assembly >> Removal

Clutch Assembly: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Using Clutch Holder (T94P-19703-AH) to hold compressor shaft from turning, remove clutch plate bolt. Discard bolt.
  2. Thread an 8-mm bolt into clutch plate, and remove clutch plate and shims. Remove pulley outside snap ring. Remove pulley assembly. See Figure. Note location of clutch coil electrical connector.
  3. Disconnect clutch coil lead. Install Field Coil Remover (T89P-19623-FH) on nose opening of compressor. Using a 2-jaw puller, remove clutch coil from compressor. DO NOT use air-powered tools when removing clutch coil.
scientia non olet · About LEMON Manuals