LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Diagnosis - F4A42 & F4A51 Automatic Transmission) >> Self-Diagnostic System >> No Communication With All Systems

No Communication With All Systems

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition off. Using a DVOM, measure voltage between ground and Data Link Connector (DLC) terminal No. 16 (Red/Black wire). See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, repair connectors and/or wiring between DLC and power supply (fusible link No. 2). See Figure . See WIRING DIAGRAMS  . Recheck communication.
  2. Using a DVOM, measure resistance between ground and DLC terminals No. 4 (Black wire) and No. 5 (Black wire). Resistance should be less than 2 ohms. If resistance is as specified, repair or replace scan tool as necessary. If resistance is not as specified at one or both terminals, repair open or high resistance in appropriate Black wire between ground and DLC. Recheck communication.
scientia non olet · About LEMON Manuals