Clutch Interlock Switch
WARNING: This page is about a different variant/trim than selected.
NOTE:
Under normal operation, engine should not crank or start unless clutch pedal is fully depressed. Adjustment is required if operation is not as specified.
NOTE:
Clutch pedal adjustments must be made before adjusting clutch interlock switch.
Fully depress clutch pedal. Measure clearance between switch body and switch actuator. See Fig 1 . Distance should be .140" (3.5 mm). If clearance is not as specified, rotate switch 1/4 turn counterclockwise to unlock. Slide switch to achieve desired clearance, and then rotate 1/4 turn clockwise to lock.