LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.4L DOHC Engine) >> Overhaul >> Cylinder Block Assembly >> Fitting Pistons

Fitting Pistons

WARNING: This page is about a different variant/trim than selected.
  1. To determine if piston-to-cylinder clearance is within specification, measure piston skirt diameter .551" (14.0 mm) from bottom of piston skirt, at 90-degree angle to piston pin. Ensure piston diameter is within specification. See PISTONS, PINS & RINGS  table under ENGINE SPECIFICATIONS.
  2. Measure cylinder bore .394" (10.0 mm) below top of cylinder bore, at middle of bore and .394 " (10.0 mm) from bottom of cylinder bore.
scientia non olet · About LEMON Manuals