LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Anti-Lock Brake System (Except Coupe)) >> Traction Control Switch >> Installation

Traction Control Switch: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install switch through top of upper shroud and snap into place. See Figure.
  2. Install the upper and lower steering column shrouds onto the lock housing of the steering column. As upper shroud is installed, guide traction control "OFF" switch wiring pigtail down right side of column and connect wiring connector to column harness.
  3. Install and securely tighten screws attaching steering column shrouds to column lock cylinder housing to 1.9 N.m (17 in. lbs.) torque. See Figure.
  4. Install instrument panel trim bolster below steering column. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  5. Connect remote ground cable to ground stud on left front shock tower.
  6. Close hood.
  7. Connect DRBIII(R) scan tool to diagnostic data link connector and check for any faults.
  8. Road test vehicle checking operation of traction control and switch.
scientia non olet · About LEMON Manuals