LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Emission Control System - Except Coupe) >> Exhaust Gas RECIRCULATION Valve >> Exhaust Gas RECIRCULATION Tube >> Installation - 4 Cylinder

Installation - 4 Cylinder

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all mating surfaces.
  2. Inspect rubber silicone seal on intake manifold. Replace seal if damaged.
  3. Install new gasket between the EGR tube and EGR valve and loose install bolts to EGR valve. See Figure.
  4. Slide clamp into the intake manifold slot. See Figure. Tighten the bolt to 11.3 N.m (100 in. lbs.).
  5. Tighten bolts to EGR valve to 11.3 N.m (100 in. lbs.) torque.
  6. Install the air cleaner box.
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals