LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Diagnosis & Overhaul - 41TE Automatic Transmission - Except Coupe) >> Gearshift Mechanism >> Installation

Gearshift Mechanism: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install shifter mechanism. See Figure. mechanism-to-floor pan nuts to 17 N.m (150 in. lbs.).
  2. Install gearshift cable into conduit bracket and onto shift pin. Install retainer clip. See Figure.
  3. Tighten cable adjuster nut to 23 N.m (200 in. lbs.).
  4. Insert interlock cable core wire into interlock adjustment lever groove. Make sure the interlock cable slug is seated in the groove. See Figure.
  5. Insert interlock cable adjuster end into bracket and snap into place. See Figure.
  6. Adjust the gearshift and interlock cables. Refer to Adjustments in this article.
    NOTE: Gearshift and Interlock cables MUST be adjusted. Refer to the Adjustments section in this article for proper procedures.
  7. If equipped with Autostick, connect the Autostick connector. See Figure.
  8. Install center console assembly. See Figure.
  9. Connect range indicator lamp and install gearshift bezel. See Figure.
  10. Install the gearshift knob and tighten set screw to 2 N.m (20 in.lbs.). See Figure.
  11. Connect the battery negative cable.
scientia non olet · About LEMON Manuals